Hammers, Rods and Spacers
CMS meets your needs for hammers, rods and spacers with a wide variety of shapes, widths, lengths, and diameters.
CMS manufactures our own hammers. We machine drill each hole and then deburr both sides to assure a satin finish. Drilling is far superior to a stamped (punched) hole, as a stamped hole tends to make a hammer swing off center and cause premature rod wear.Hammers are made out of Special Alloy Steel. These same alloys are used by the largest agricultural manufacturers for plow points and draw bars.
|
| |
|
|
|
|
|
|
|
|
|
|
Whatever your requirements, CMS has rods/pins on hand for immediate shipment. We offer rods/pins in any length, diameter, and configuration. All rods/pins must pass the Rockwell hardness test before shipment. Rods are available for most make and model hammermills. |
| |
|
|
|
|
|
|
All CMS spacers have a polished finish for safe, clean handling and precise fit. Sizes range from 1/2 inch ID to 1-1/4 inch ID are available in any width. Single-split and double-split lock collars are in stock. Spacers are available for most make and model hammermills. |
|
